Turning Off - Bissell Spot Lifter 1715 Series User Manual

Deep Cleaning Upholstery
Check manufacturer's tag before cleaning. "W" or "WS" on the
1.
tag means you can use your Spot Lifter. If tag is coded with an
"S" (with diagonal strike-through), or says "Dry Clean Only," do
not proceed.
If manufacturer's tag is missing or not coded, check with your
2.
furniture dealer.
If possible, check upholstery stuffing. Colored stuffing may
3.
bleed through fabric when wet.
Cleaning Spills From Hard Surfaces
Activate vacuum/pump by pressing Power Switch "ON".
1.
Press front of Spot Lifter firmly against surface to vacuum spill.
2.
Press trigger to spray cleaning solution.
3.
Press front of Spot Lifter firmly against surface to vacuum
4.
cleaning solution.
Check the Collection Tank and empty the tank if it is full. (see
5.
WHEN YOU'RE DONE, page 9).
If Spot Lifter stops spraying, turn off Power Switch and check
6.
cleaning solution level. Refill if needed. Never run dry.
When You're Done
Turn Power Switch to "OFF" position.
1.
Empty the Collection Tank after each use.
2.
Carry Spot Lifter to sink or drain.
3.
Remove the Collection Tank by pressing the Tank Release
4.
Button at the top of the tank, immediately in front of the
handle. The Tank will pivot out on a "hinge" at the bottom of
the unit. Keep one hand underneath Tank as it releases, then
gently lift to disengage the Tank from the hinge.