Advertisement
User Manual
Part Number: 87340-1001, Rev. 0
Section 1: Display Module
1.1
Local Display Module
Display Module with Bluetooth
The Local Display module consists of the following as shown in Figure 1:
•
•
•
•
Figure 1
1.1.1
1.1.2
Display Module
Graphics Display
Message Center
Control Knob and Selector Knob
Three LEDs
Local Display Module (LDM)
Graphics Display and Message Center
The graphics display shows the mode of operation, valve status, position, torque, and
alarm symbols. The message center displays actuator setup selections, data entry
feedback, and alarm messages. When no alarms are active and the valve is not moving
or is not at either limit, the message center will be blank.
Control Knob and Selector Knob
The control knob performs normal Open/Stop/Close function in the local control mode
and YES/NO function in the "MONITOR/SETUP" mode as detailed in Table 1.
The NO selection increments the displayed value but does not decrement.
To decrement continuously hold the NO position until the highest value is reached.
The display value will then start at the lowest value and increment from there. If the
control knob is held in the NO position for more than 2 seconds the incrementing rate
will increase from 0.5 seconds per new value to 0.1 seconds per value.
- Model 87340.
®
LEDs
Graphics Display
Message Center
Control Knob
Selector Knob
Display Module
April 2015
1
Advertisement
