Installation Procedure - ZKTeco FaceKiosk Series User Manual

 FaceKiosk Device must be stationed at an indoor place with good lighting.
 The camera is especially designed for face recognition. While placing the device, please do not point the
camera towards doors, windows, or other places with strong light, to avoid overexposure of the camera and
affecting the face verification effect.

1.2.2 Installation Procedure

Installation Procedure (Vertically):

The upper portion of the device and the base are separately packed. The installation procedure is as follows:
Step 1: Open the packing box of the device from the side. Take out the base and put it on the top of the base box
to avoid scratching. Place the packing box upside down, and take out the upper portion (put it on the side and avoid
bumping).
Step 2: Remove the protective film from the base and insert the base into the card slot on the upper portion of the
device.
Step 3: Open the packing box, take out the screws and wrench. Use screws to secure the base.
Step 4: Keeping the device upper part vertical, remove its protective film.
Step 5: Connect the power supply and turn on the switch at the rear of the machine.
Installation Procedure (Wall Hanging):

The following tools are required for installation:
2 FaceKiosk Series User Manual
Operating temperature
Operating humidity
Storage humidity
–10°C to 50°C
10% – 98%
10% – 98%