Table of Contents
Advertisement
the four hanging nails on the hanging board.
Note: Due to the weight factor, the FaceKiosk device above 26-inch should be installed with the help of two
people. After installation, make sure that it is fastened properly.
1.3. Precautions
1. This product can be used in an AC voltage range of 110–240 V. If the input voltage is less than 110 V or greater
than 240 V, the device will not start or it may get damaged.
2. Use a socket equipped with a ground cable. Use the power cable provided in the device package to ensure
proper operation of the device.
3. Keep children away from socket and follow electrical precautions.
4. Keep the device away from water, heat sources, high-voltage power transmission networks, and places with
vibration or prone to shocks, to avoid short circuits and instability of the device.
5. Non-professionals should not open the rear door in power-on situation because of the high pressure inside. Shut
down the device before opening the rear door.
6. Disconnect the power supply from the device if it will not be used for a longer period.
7. Avoid frequent switching on/off the device to avoid affecting the LCD service life. Start the device 3 minutes after
the shutdown.
8. If any kind of liquid enters into the device, disconnect the power supply immediately and contact a professional
for repair.
9. If the device emits odors, disconnect its power supply immediately and contact a professional for repair.
10. Set the display brightness and contrast lower than the maximum value, to extend the LCD service life.
Note: This product requires a 110–240 V input voltage and a total power of 70 W. This device has passed the safety
inspection and had obtained 3C certification.
1.4. Notes for Access Control Wiring
1.4.1
Access Control Interface
Access Control interface is divided into 5 rows: J5, J6, J7, J8, J9. Currently J8 and J5 interface are used, rest others are
reserved.
4 FaceKiosk Series User Manual
Advertisement
Table of Contents
