Table of Contents
Advertisement
The software will now be installed on your computer. You can
watch the progress bar to determine how much time is left in the
installation.
DETECTING YOUR SYSTEM
As part of the installation process, you can let VCS help you detect and set
up your system. Just click
If you would rather not set up any systems at this time or already know
what you are doing,, then press
setting up any systems.
You will want to take note of the following information should you have any issues with communicating with your
system after the installation process. Most users will not have to make any modifications to their computers, but
some cases might require exceptions be made for ports. For those instances, your network administrator can take
care of that for you.
Note to Network Administrators:
communicate with the system. Please make sure that these ports are open and
available:
IP: 23, 29 and 30
UDP: 6201, 6202, 6203, 6207 and 6221
So before we begin, let's make sure that the Engraving System is turned on.
You can look at the Touch Screen on the pendant to verify. If you see the
menus on the pendant then your machine is turned on.
to do this.
to exit the installer without
VCS uses the following ports in order to
Hide quick links:
Advertisement
Table of Contents
