Viper Communication Suite Installation - Xenetech Duo 1218 Installation & Table Manual

The next three dialog boxes all refer setting the software up for an Ethernet connection. Your XL Duo Engraving
System will only run via Ethernet. Please select yes to the remaining three dialog boxes.

VIPER COMMUNICATION SUITE INSTALLATION

The XGW software can be set up to operate the Viper System as Engraver #1 or #2
Please make sure to read these instructions carefully so you will have a complete
understanding of how to set your system up correctly. If you have any questions on
the type of connection to use, contact your distributor or Xenetech.
Insert the Xenetech Professional Engraving Systems software CD into
your CDROM drive. If auto play is enabled on your PC then you will see
the Xenetech Installation menu. If auto play is not enabled, then browse
the CD and double click on the
CD and will also show the Xenetech Installation menu.
Click on the
To Install the Viper Communications Suite, click on the
Select to begin the installation.
icon. Doing this will run the
button.
button.