C8.3.10 Off Line Error - WEG SSW900 Series User Manual

✓
NOTE!
After changing this configuration, for the modification to be effective, the equipment must be turned off
and then turned on again, or the configurations must be updated through C8.3.1.
C8.3 Anybus-CC
C8.3.7 Gateway
Range:
Properties:
Description:
It allows programming the IP address of the standard gateway used by the module Anybus-CC EtherNet/IP, Modbus
TCP or PROFINET IO. It is only effective if C8.3.4 = Parameters.
✓
NOTE!
After changing this configuration, for the modification to be effective, the equipment must be turned off
and then turned on again, or the configurations must be updated through C8.3.1.

C8.3.10 Off Line Error

Protection against interruption in the communication with the network master.
If for some reason there is an interruption in the communication between the product and the network master,
a communication error will be indicated, alarm A129 or fault F129 will be shown on the HMI, depending on the
programming of C8.3.9.1, and the action programmed in C8.3.9.2 will be executed.
It only occurs after the equipment is online. This error is generated for the modules Anybus-CC DeviceNet,
EtherNet/IP, Profibus DP and PROFINET IO.
C8.3.10 Off Line Error
C8.3.10.1 Mode
Range:
Properties:
Description:
It allows configuring the tripping mode of the protection against interruption in the communication with the network
master.
Indication
0 = Inactive
1 = Fault F129
2 = Alarm A129
C8.3.10 Off Line Error
C8.3.10.2 Alarm Action
Range:
Properties:
Description:
Action for the Anybus-CC Offline communication alarm.
The actions described in this parameter are executed through the writing of the respective bits in the control word
of the SLOT to which the accessory Anybus-CC DeviceNet, EtherNet/IP, Profibus DP or PROFINET IO is connected.
Thus, for the commands to be effective, the equipment must be programmed to be controlled by the network interface
used. This programming is done through menu C3.
0.0.0.0 ... 255.255.255.255
0 ... 2
No tripping.
Trips as fault. Disables the motor.
Trips as alarm. Action described in C8.3.10.2.
0 ... 4
Description
C CONFIGURATIONS
Default: 0.0.0.0
Default: 0
Default: 3
SSW900 | 20