Honeywell Experion PKS Specifications And Technical Data page 26

EP03-300-200
Release 200
Table 8.b. Supervisory Process Control Network
Supervisory Networks per Server
(Mixed Supervisory FTE, ControlNet, & Ethernet on the
same Server is not supported.)
Total ControlNet Connection Limit per PC ControlNet
Interface Card (PCIC)
(Each node (C200 Controller, Server, FIM-only Chassis, and
ACE) uses 1 PCIC connection regardless of where they
reside in the system.)
Maximum Number of Nodes allowed, including
Controllers, Servers, FIM-only Chassis, and ACEs
Maximum Allowable Combinations of Controllers per
2,3
Server
Maximum Number of ACEs supported per Server
(The ACE application requires a separate server)
Network Topology
Data Rate
Media Redundancy
1
Qualified for Redundant Server + 10 non-Redundant controllers; Fieldbus (FIMs) is not supported on an Experion
PKS system that uses Ethernet as the supervisory process control network; ACEs do not exist on a Supervisory
Ethernet Configuration
2
Controller Definitions including PLCs which make
use of the same network and utilize Server SCADA
connections:
To ensure no single point-of-failure exists, multiple
Controllers per chassis are not supported. The
ACE is not included in this limit.
3
A Logix5550 or PLC5/C counts as a Controller only if a SCADA connection is formed to it. Use of the EXCHANGE
FB does not constitute a SCADA connection.
Experion PKS CEE-based Controller Specifications and Models
FTE ControlNet
(Using FTE
Bridge Module
TC-FTEB01)
1 high 1 redundant or
availability non-redundant
network
serviced by 1 serviced by 1
redundant or redundant or
non- non-redundant
redundant
(1 ControlNet card
Server
N/A
200
(includes all
FTE nodes
within a FTE
community)
10 10
(whether
redundant or redundant or
non- non-redundant)
redundant)
2
Dual Switch
tree medium bus
10 5 Mbits/sec
Mbits/sec
Redundant Single media
media or redundant
operation
One controller in a Non-
Redundant configuration
equals:
1 C200
3
1 CL5550
3
1 PLC5/C or E
1 SLC (Ethernet only)
1 SIM-C200
23
December, 2003
Version 1.0
Ethernet
(Non-redundant
10Mb Ethernet
using TC-
CEN021)
1 non-
redundant
network network
serviced by
1 redundant
or non-
Server redundant
Server
per PC)
(FTE-based
Servers will
not support
Ethernet
Supervisory
Control
Network)
127 N/A
1
32 12
10
(whether (non-
redundant)
2 Not
supported
Shared Switched
10
Mbits/sec
Non-
redundant
media only
operation
supported.
One controller in a
Redundant configuration
equals:
2 C200s in a Chassis Pair
with 2 Redundancy
Modules
2 CL5555s in a Chassis
Pair with 2 Redundancy
Modules