Integrated Devices Screen; Serial Communications Screen - Dell PowerEdge E02B Owner's Manual

Menu Item Description
If the operating system supports UEFI, you can set this option to UEFI. Setting this
field to BIOS allows compatibility with non-UEFI operating systems. By default, the
Boot Mode option is set to BIOS.
Boot Sequence Allows you to enable or disable the boot sequence retry feature. If this field is
Retry enabled and the system fails to boot, the system reattempts the boot sequence
after 30 seconds. By default, the Boot Sequence Retry option is set to Disabled.
BIOS Boot Settings Allows you to enable or disable BIOS Boot options.
UEFI Boot Settings Allows you to enable or disable UEFI Boot options. The Boot options include IPv4
PXE and IPv6 PXE. By default, the UEFI PXE boot protocol is set to IPv4.

Integrated Devices screen

Menu Item Description
User Accessible Allows you to set the user accessible ports. Selecting All Ports Off disables all USB
USB Ports ports. By default, the User Accessible USB Ports option is set to All Ports On.
Embedded NIC1 Allows you to enable or disable the Operating System interface of the embedded
and NIC2 NIC1 and NIC2 controller. By default, the Embedded NIC1 and NIC2 option is set
to Enabled.
OS Watchdog Allows you to enable or disable the OS wacthdog timer. When this field is enabled,
Timer the operating system initializes the timer and the OS watchdog timer helps in
recovering the operating system. By default, the OS Watchdog Timer option is set
to Disabled.

Serial Communications screen

Menu Item Description
Serial Allows you to enable the COM port or Console Redirection options.
Communication
Serial Port Address Allows you to set the port address for serial devices. By default, the Serial Port
Address option is set to COM1.
Failsafe Baud Rate Displays the failsafe baud rate for console redirection. The BIOS attempts to
determine the baud rate automatically. This failsafe baud rate is used only if the
20
NOTE: Setting this field to UEFI disables BIOS Boot Settings menu. Setting this
field to BIOS disables the UEFI Boot Settings menu.
NOTE: This option is enabled only if the boot mode is BIOS.
NOTE: This option is enabled only if the boot mode is UEFI.
NOTE: Only Serial Device 2 can be used for Serial Over LAN (SOL). To use
console redirection by SOL, configure the same port address for console
redirection and the serial device.