Installing A Hard Drive/Ssd; Shutdown Procedure For Servicing A Hard Drive/Ssd - Dell PowerEdge E02B Owner's Manual

Hide thumbs Also See for PowerEdge E02B:

Table of Contents

hard-drive/SSD connector (on backplane)

Figure 22. Removing and installing a 1.8 inch SSD

SSD connector (on backplane)

SSD carrier handle

Installing a hard drive/SSD

CAUTION: When a replacement hot-swap hard drive/SSD is installed and the sled is powered on,

the drive automatically begins to rebuild. Make absolutely sure that the replacement hard

drive/SSD is blank or contains data that you wish to have over-written. Any data on the

replacement hard drive/SSD is immediately lost after the drive is installed.

NOTE: Not all operating systems support hot-swap drive installation. See the documentation

supplied with your operating system.

NOTE: The 2.5 inch hard-drive/SSD configuration supports four warm-swap hard-drives/SSDs. Each

hard-drive/SSD is assigned to a specific node, and the node to which it is assigned must be turned

off before servicing the hard-drive/SSD.

Open the hard-drive/SSD carrier handle.

Insert the hard-drive/SSD carrier into the drive bay. Carefully align the channel on the hard-drive/SSD

carrier with the appropriate drive slot on the sled.

Push the drive carrier into the drive bay.

Rotate the carrier handle to the closed position while pushing the carrier into the slot until it locks

into place.

For the 2.5 inch hard-drive/SSD configuration, turn on the node to which the hard-drive/SSD is

assigned, using the iDRAC.

The status LED indicator displays a steady green light if the drive is installed correctly. The drive

carrier LED green indicator flashes as the drive rebuilds.

NOTE: This section is applicable only when you have to turn off the sled to service a hard drive/SSD.

In many situations, the hard drive/SSD can be serviced while the sled is powered on.

hard-drive/SSD carrier handle

SSD

release button

Table of Contents

Poweredge fm120x4