Grounding; Figure 3-1 Grounding Bolt - CommScope Node AM4 Manual

3.2.3. Grounding

Grounding (earthing) must be carried out.
Connect an earth-bonding cable to the
grounding connection provided at the
outside of the unit. Do not use the
grounding connection to connect external
devices.
After loosening the hex nut, connect
the earth-bonding cable between the
two washers, and fasten all parts again
with the hex nut:
GND bolt M8

Note: The PE cables must have a minimum cross section of 16 mm
The local ground cable requires an adequate ear for the M8 GND bolt.
Page 24
Grounding
bolt
Hexagon nut M8 DIN934
Locking ring M8 DIN127
Local ground cable

figure 3-1 Grounding bolt

MF0121ACP_uc.docx
Plain washer M8 DIN125
Cabinet
Contact washer M8
Plain washer M8 DIN125
Manual for Node AM4
3. Installation
2 .