Filament Replacement Notes - JGaurora A8S User Manual

Click "Print"
Note: When printing, if the first layer does not adhere to the platform, please stop printing and re-level
the printing platform and the nozzle, to set the correct gap.

4.6 Filament replacement notes

1) While printing a model, if the filament is close to running out, please follow these steps for reloading filament:
a: Click "PAUSE" at the printing menu, the X axis will then go to the home position.
b: Next click "OUT" to eject the filament out and remove the spool after the filament is ejected.
c: Install a new roll of filament, then click the "IN" icon until feeding is completed. Once the filament reaches the
nozzle, as small amount of plastic should start to extrude from the nozzle, in order to ensure the nozzle is primed for
printing. If this does not occur, extrude plastic manually until the nozzle is primed.
d: Click the "Back" button to enter into the model printing mode, then click the "RESUME" button to resume printing.
2) When replacing filament, please ensure the nozzle has been preheated to operating temperature first, before
performing the filament change.
nozzle and extruder assembly.
Please do not pull it out violently, otherwise it will cause severe damage to the
16
----3D Printer User Guide
Select the file you
wish to print.