Maintenance - Vent-Axia HR205 User, Installation & Servicing Instructions

Release handand
fastners (Butterfly Bolts)
Air inlet
filter pull
out, brush
& vacuum
clean
Remove
covers
Warning
to inspect
LH/RH
Fans &
Fire
Damper
(clean as
required)
HR205
Pull out & clean the
Condensate Tray
Remove
the cooker
hood
filters
for cleaning
View from
below the
unit
Fig. 24
24
Pull forward & remove
the outer case
Use strap to pull
out heat
exchanger.
U P
F R
O N
T
UP
FRONT
Service
Pull Cooker
Hood forward

9.0 Maintenance

Important: Before servicing ensure that
the appliance is isolated from the
electrical supply. After isolating from the
electrical supply, allow one minute for the
fans to stop rotating before servicing the
appliance.
1. HR205 only -Extend the telescopic hood and
remove the two metal filters. The cooker hood
filters can be washed in a dishwasher;
alternatively a hot hand wash will suffice. Check
and clean the filters if necessary. Dry the filters
thoroughly before re-fitting.
2. Lift off the front door panel by releasing the
two hand screws and lifting upwards.
3. Identify the air inlet filter and remove by
pulling forwards.
Taking note of the offset sliders, carefully
remove the heat exchanger by gently pulling
forwards.
4. Remove the bottom electrical cover by
releasing the 3 screws, pulling the panel
forwards and disconnecting the earth lead to the
panel.
5. Loosen the two screws on each side plate and
lift to remove.
6. HR205 only - Check the cooker hood inlet for
debris and fat deposits. Clean as required.
Check the fire damper is in satisfactory condition
and unaffected by debris and fat deposits.
Replace if necessary.
Wiring 7. Check both fans, fan compartments and
exhaust duct outlets for deposits. Clean as
necessary.
8. Remove the condensate tray by pulling
forwards. Check and clean if necessary.
9. Check the condition of the four heat
exchanger sealing strips and front door seal.
Replace all seals as necessary (Fig. 24).
10. Carefully wash the heat exchanger in
warm soapy water taking care not to loosen the
heat exchanger fins. Thoroughly dry the heat
exchanger before re-fitting.
Note: Ensure the heat exchanger is
located correctly in the offset sliders.
11. Carefully vacuum the air inlet filter. Replace if
necessary.
12. Re-assemble in reverse order and re-fit the
outer door ensuring the door makes a good seal.