Not Operating - Electrolux Kelvinator KSV26HRB Diagnostic Manual

Not Operating

:
# Check for supply voltage from the power supply cord to the indoor main PCB.
# Try operating the unit by the forced operations button: By pressing the button once, the unit should
activate in Auto mode. By pressing this button twice, within five seconds, the unit should activate in
Cooling mode.
If the unit can be operated by the forced operations button & the green stand by light was flashing on the
display PCB assembly, prior to pressing the forced operation button, check the remote controller.
If the unit can be operated by the forced operations button & the green stand by light was off on the
display PCB, replace the display PCB assembl y.
Active & Neutral supply voltage points from
service cord to main indoor PCB.
Stand by indicator on Display PCB assembly.
Button located on top right hand side of
indoor unit behind filter cover.
Page 3 KSSSI92