Displaying Port Mirroring - H3C S3610 Series Operation Manual

Operation Manual – Port Mirroring
H3C S3610&S5510 Series Ethernet Switches
Add a port
to the port
mirroring
group as
the
destination
port
Enter destination interface
view
Add the
port to the
remote
port
mirroring
VLAN
Note:
A destination port cannot be a member port of the current mirroring group.
A port can be configured in only one mirroring group, and a VLAN can be used by
only one mirroring group.
It is not recommended to enable STP, RSTP or MSTP on the destination port;
otherwise, the mirroring function may be affected.
Only existing static VLANs can be configured as remote port mirroring VLANs. To
remove a VLAN operating as a remote port mirroring VLAN, you need to restore it to
a normal VLAN first. A remote port mirroring group gets invalid if the corresponding
remote port mirroring VLAN is removed.

1.4 Displaying Port Mirroring

Follow these steps to display port mirroring:
Display the configuration
of a port mirroring group
To do...
In system mirroring-group group-id
view monitor-port monitor-port-id
interface interface-type
interface-number
In interface
[ mirroring-group group-id ]
view
monitor-port
quit
interface interface-type
interface-number
The port is
an access port access vlan rprobe-vlan-id
port
The port is a
port trunk permit vlan
trunk port rprobe-vlan-id
The port is a port hybrid vlan rprobe-vlan-id
hybrid port { tagged | untagged }
To do...
display mirroring-group { groupid |
all | local | remote-destination |
remote-source }
Chapter 1 Port Mirroring Configuration
Use the command...
Use the command...
1-7
Remarks
You can add a
port to a
remote port
mirroring group
as the
destination
port in either
system view or
interface view.
They achieve
the same
purpose.
—
Perform one of
these three
operations
according to
the port type.
Remarks
Available in
any view