H3C S3610 Series Operation Manual page 12

Operation Manual – Port Mirroring
H3C S3610&S5510 Series Ethernet Switches
[SwitchB] interface Ethernet 1/0/1
[SwitchB-Ethernet1/0/1] port link-type trunk
[SwitchB-Ethernet1/0/1] port trunk permit vlan 2
[SwitchB-Ethernet1/0/1] quit
# Configure port Ethernet 1/0/2 as a trunk port and configure the port to permit the
packets of VLAN 2.
[SwitchB] interface Ethernet 1/0/2
[SwitchB-Ethernet1/0/2] port link-type trunk
[SwitchB-Ethernet1/0/2] port trunk permit vlan 2
3) Configure Switch C.
# Configure port Ethernet 1/0/1 as a trunk port and configure the port to permit the
packets of VLAN 2.
<SwitchC> system-view
[SwitchC] interface Ethernet 1/0/1
[SwitchC-Ethernet1/0/1] port link-type trunk
[SwitchC-Ethernet1/0/1] port trunk permit vlan 2
[SwitchC-Ethernet1/0/1] quit
# Create a remote destination port mirroring group.
[SwitchC] mirroring-group 1 remote-destination
# Create VLAN 2.
[SwitchC] vlan 2
[SwitchC-vlan2] quit
# Configure VLAN 2 as the remote port mirroring VLAN of the remote destination port
mirroring group. Add port Ethernet 1/0/2 to the remote destination port mirroring group
as the destination port.
[SwitchC] mirroring-group 1 remote-probe vlan 2
[SwitchC] mirroring-group 1 monitor-port Ethernet 1/0/2
After finishing the configuration, you can monitor all the packets sent by Department 1
and Department 2 on the Data monitoring device.
Chapter 1 Port Mirroring Configuration
1-11