Bandai Namco GALAGA ASSAULT Setup And Operation Manual page 20

Improper number of credits given
when coins or bills are inserted
Coin meter does not work
Exits Test Mode every 3 seconds
NO VIDEO message
No Signal
Dongle Not Present
Connect RIO Board or
RIO Board Missing
GALAGA ASSAULT ™ & © BANDAI NAMCO ENTERTAINMENT Inc.
Incorrect setting in Adjustments
Faulty wiring
Faulty coin mech
Blown fuse(s) on PCB
Test button stuck in ON position
Video cables not plugged in properly
Video or power cable not secure
PC not turned on
Dongle missing or disconnected
Faulty USB port
USB cable disconnected
No power to RIO board
Adjust settings
Disconnect cabinet from AC power.
Verify wires are firmly connected to
coin mech and bill validator and
ground wires are properly
connected. Verify no wires are
frayed or shorting to ground.
Verify coin mech is not jammed.
Ensure coin mech is properly
aligned and latched to coin door.
Replace 5A fuse(s) on PCB
Slide or toggle button off after Test
Menu appears
Reattach and tighten power and
video cable to monitor.
Check and secure cable.
Turn PC power switch on. Ensure
IEC cable tightly plugged in. Trace
cable back to source to ensure
continuity.
Find dongle cable and reseat in USB
port
Insert dongle cable in different USB
port
Check USB connection from PC to
RIO board
Check for proper voltage (+5V,
+12V) at P2 connector
19