Hitachi 2000 Series Hardware Reference Manual page 46

• No flow control
7. Start the server.
8. Assign a unique IP address for SSLoader on this server (in order to allow a new
firmware package to be loaded later in this process, a unique SSLoader IP address
must be assigned to the server with the replaced module).
From the terminal emulation program running on the laptop, during the SSLoader
portion of the server boot process, press the space bar to display the SSLoader
menu.
a. From SSLoader Main menu, select "Configuration Menu."
b. Select the option to "Show 10/100 IP Parameters."
If the output doesn't show a valid IP address, select "Set 10/100 IP
parameters" and set the server SSLoader IP address to a unique address on
the same network as the laptop. Note that the subnet mask must match the
laptop setting.
c. Exit from the Configuration menu and select "Reset System" from the main
menu.
9. During the SSLoader portion of the server boot process, press the space bar to
display the SSLoader menu.
10. Once the address is set, ping that address from the laptop to verify connectivity.
11. If the installed package version is correct, boot the server and skip the remaining
steps; otherwise, proceed to the next step.
a. From the main menu select "Package Menu."
b. From the displayed package menu, select "Select Default Package."
If the correct firmware package is listed, select it from the available list.
The server will then validate the data integrity of the package file.
If the validation is successful, exit from the package management menu and
choose "Continue Booting" from the main menu.
The replacement process is now complete, and no further action should be
required.
If the firmware file is not listed, or if the package is listed, but fails
validation, proceed to step 12.
12. From the laptop, upgrade the server's firmware package.
a. Start a command window.
b. Go to the C:\TEMP directory (or wherever you stored the ssc executable and
the software package).
c. Start uploading the new package to the server by entering the following
command:
ssc laptop_IP_address package-upgrade package_name
where laptop_IP_address is the IP address you set (in step 2-b) and
package_name is the software package to upload.
34 Hitachi High-performance NAS Platform