Disinfection; Admissible Disinfectants; Non-Admissible Disinfectants; Battery - mbnet Engineering ergo vac Operating Manual

7.3

Disinfection

Disinfection removes certain bacteria and viruses. Please refer to the manufacturer's infor-
mation. Use commercially available disinfectants intended for clinics, hospitals and medical
practices.
Disinfect the device in the same way as described for cleaning the device in Chapter 5.2.
7.3.1

Admissible Disinfectants

Isopropanol (50%)
Propanol (35 %)
Aldehyde (2 – 4 %)
Ethanol (50 %)
7.3.2

Non-admissible Disinfectants

Organic solvents
Ammonia-based detergent
Abrasive cleaning agents
100% alcohol, Virex, Sani-Master
HB Quat
Conventional detergents (e.g. Fantastic
Conductive solutions
Solutions or products containing the following ingredients:
7.4

Battery

No maintenance is required for the battery.
Depending on use, the battery should be replaced about every 4 years or if the battery
life falls significantly below 1 hour.
As long as the device is not in use, you should make sure that the battery is not com-
pletely depleted. Should the device not be used for more than three months, the battery
must be protected from complete discharge by recharging it.
7.4.1

Charging the Battery

A completely depleted battery takes about 3.5 hours to fully charge (when power is off). A completely depleted battery takes about 3.5 hours to fully charge (when power is off).
If the device is switched on during charging, the charging time may be longer. If the device is switched on during charging, the charging time may be longer.
The device can stay connected to the power grid without risk to the battery.
Connect the device to the power grid.
all products that are suitable for sensitive surfaces,
such as:
®
Acetone
Ammonium chloride
Betadine
Chlorine, wax or wax compound
Ketone
Sodium salt
User guide
Bacillol 30 foam / Bacillol 30 Tissues
® ®
(10% Propanol-1, 15% Propanol-2, 20% Ethanol)
Mikrozid ® AF (25% Ethanol, 35% 1Propanol-1)
, Tilex etc.)
® ®
ergo vac
Seite 29