Maintenance And Care; Visual Inspection - mbnet Engineering ergo vac Operating Manual

ergo vac
7

Maintenance and Care

The device requires regular checks (Chapter 7.5). The test results must be recorded in
writing and compared to the values in the accompanying documents.
Maintenance work not described in this section may only be performed by a qualified,
authorised technician.
The following table indicates the intervals and responsibilities of the maintenance work
required. Local regulations in your country may stipulate additional or different inspection
intervals and tests.
Before every use
Every 6 months
Every 12 months
The useful life of the device electrodes is estimated to be 2 years.
7.1

Visual Inspection

Visually inspect the unit and cable assemblies for the following:
Device, housing and mains cable (not damaged or cracked)
Keypad (not damaged or cracked)
Electrode cable sheathing and connectors (undamaged)
No cracks, abrasion or wear in any cable assembly
Input/output connectors (not damaged or cracked)
In addition to the visual inspection, the device should be switched on and the functions of
the operating field should also be checked. In this way, you can check that:
the device performs faultlessly
the display works
Warning
Defective units or damaged cables must be replaced immediately.
Seite 20
User Guide
Interval
Visual inspection of the device and ECG electrodes
Visual inspection of the device
(see page 21, 7.5 Inspection report)
- Cables and accessories
- Mains cable
Functional tests according to the instructions
(see page 30, 7.5 Inspection report)
Safety test according to § 11 MPBetreibV
Maintenance step Responsible
User
User
qualified staff