Leggett & Platt S-cape+ 2.0 Owner's Manual page 8

mattreSS retaiNer iNStallatioN (oPtioNal)
Mattress is equipped with a Micro-Hook™ system
to captivate the mattress (FIGURE 4), but if
desired a mattress retainer can also be used. If
installing a mattress retainer, proceed to Step 9.
If not installing a mattress retainer, proceed to
Step 10.
FIGURE 4
Micro-Hook™
SYSTEM
Simplicity™ 3.0
BASE SHOWN
(articulated)
SteP 9
Install mattress retainers at the foot end of the adjustable base as
follows:
a. Locate grommeted holes at foot of base (FIGURE 5).
b. Place mattress retainer ends into grommeted holes in top
surface of adjustable base (FIGURE 5). Press down until
horizontal retainer section is flush against base.
FIGURE 5
MATTRESS
RETAINER
SteP 10
Install mattress on adjustable base.
Typical adjustable base installation is now complete.
8
S-cape 2.0 / S-cape + 2.0 / Simplicity™ 3.0 Owners Manual 290-0010-c
® ®
iNStallatioN
THIS PRODUCT SHOULD NOT BE USED WITH
EITHER A DUST RUFFLE OR A MATTRESS
ENCASEMENT. IF EITHER A DUST RUFFLE
OR MATTRESS ENCASEMENT IS NEEDED,
THEN A MATTRESS RETAINER BAR IS
IMPORTANT!
REqUIRED.
Micro-Hook™
DETAIL