Leggett & Platt S-cape+ 2.0 Owner's Manual page 11

Program Two Remotes to Operate One Base - Bases
are factory programmed to operate individual
bases. To program two remotes to operate one
base, perform the following numbered procedure.
If programming fails, initiate the programming
procedure a second time.
SteP 1
UNPLUG the base from the electriclal power source
(if plugged in). Wait 3 minutes.
SteP 2
Plug the base into the electrical power source.
You now have 3 minutes to complete the
programming procedure.
SteP 3
Simultaneously press and hold the head up and foot
up buttons on remote control 1 until the backlight
flashes. Release both buttons and set remote control
1 aside without pressing any other button.
NOTE: If any button is pressed, remote control/
control box will exit pairing mode.
SteP 4
Simultaneously press and hold the head up and foot
up buttons on remote control 2 until the backlight
flashes. Release both buttons.
Press the head up or foot up button on remote
control 2 to verify base functions.
Press the head up or foot up button on remote
control 1 to verify base functions.
Two remote controls are now programmed to operate
one base.
REMOTE REMOTE
CONTROL 1 CONTROL 2
remote coNtrol ProGrammiNG
Program Two Remotes to Operate Two Bases -
Bases are factory programmed to operate individual
bases. To program two remotes to operate two
bases, perform the following numbered procedure.
If programming fails, initiate the programming
procedure a second time.
SteP 1
UNPLUG both bases from the electrical power
source (if plugged in). Wait 3 minutes.
SteP 2
Plug both bases into the electrical power source.
You now have 3 minutes to complete the
programming procedure.
SteP 3
Simultaneously press and hold the head up and foot
up buttons on remote control 1 until the backlight
flashes. Release both buttons and set remote control
1 aside without pressing any other button.
NOTE: If any button is pressed, remote control/
control box will exit pairing mode.
SteP 4
Simultaneously press and hold the head up and foot
up buttons on remote control 2 until the backlight
flashes. Release both buttons.
Press the head up or foot up button on remote
control 2 to verify base functions.
Press the head up or foot up button on remote
control 1 to verify base functions.
Two remote controls are now programmed to operate
two bases.
S-cape 2.0 / S-cape
®
REMOTE REMOTE
CONTROL 1 CONTROL 2
+ 2.0 / Simplicity™ 3.0 Owners Manual 290-0010-c
®
BASE 1
BASE 2
11