Leggett & Platt S-cape+ 2.0 Owner's Manual page 15

FIGURE 10
CONTROL BOx
CONNECTION CORD
CONNECTED TO
POWER DOWN DEvICE
SteP 6
Press the FLAT BUTTON on the remote control until the base is in
the flat position. BASE WILL MOVE TO THE FLAT POSITION VERY
SLOWLY. Note: Batteries in the power down device will only work for
one use, then will need to be replaced.
SteP 7
Reconnect control box connection cord to power supply "brick" and
plug main power cord into electrical power source (FIGURE 11).
FIGURE 11
ELECTRICAL
POWER
SOURCE
MAIN
POWER
CORD
When power is restored from outage, base is ready to resume normal operation.
PoWer doWN oPeratioN
S-cape 2.0 / S-cape + 2.0 / Simplicity™ 3.0 Owners Manual 290-0010-c
® ®
15