Motorola R-2002A Manual page 244

23 VERSION
24 SEND-SN
25 MEM
26 RSVSI
27 RCVVI
28 WSTS
29 WSTV
30 BIBIT
31 TERMINATE
32 SATON
33 SATOFF
34 CDATA
15 HITNON
36 HITNOFF
37 LOTNON
38 LOTNOFF
39 INVM
-Hands-free mark. This 1-bit mark when set to 'J' indicates that the mobile equipment is 01
tioned for use with a hands-free control unit.
-Return the software version information to the R2008D/R2010D.
..,
-Return the 32-bit serial number to the R2008D/R2010D. Display in hexadecimal.
-Return the resident memory data located at the address specified in the 2 bytes followin
the command. The first and second bytes shall contain, respectively, the most and lea!
significant parts of the 16-bit address.
-Receive contiguous 1-word messages on the control channel. Perform majority voting an.
error correction on each message. Maintain separate counts of the number of uncorrectabl
and correctable errors detected until a terminate command is received. If the count exceed
255 (decimal), a count of 255 is to be returned.
- Same as RCVS I except on the voice channel.
•
-Receive contiguous 1-word messages on the control channel. Maintain a count of th
number of word synchronization sequences (11100010010) detected until a terminate com
mand is received. The counter shall be 16 bits wide and the data shall be returned in th1
following format:
BYTE I 15------ 8
BYTE 2 1 - - - - - - 0
-Same as WSTS except on the voice channel.
- Receive continiuous forward control channel data, extract and perform majority voting or
the busy-idle bits, and respond to status commands, and reiUrn the currem state of the rna·
jority voted busy-idle bit. Reception of an INIT command terminates sequence.
-Terminate operation off the previously issued RCVSI, RCVVI, WSTS, or WSTV corn·
mand and return the data collected to the TS.
-Enable the transmission of SAT. The byte of data following the operational code shall con·
tain the color code of the SAT frequency that the transceiver unit may expect to receive (see
table below). SAT shall be transmitted if the carrier is currently on or if a subsequent
carrier-on command is received.
COLOR CODE VALUE
00
OJ
02
-Disable the transmission of SAT.
SAT FREQUENCY
5970HZ
6000HZ
6030HZ
-Transmit continuous 5-word reverse control channel messages. The digital color code shall
be 10. Each of the 5 words shall consist of the 48-bit data pattern specified by the 6 bytes of
data following the command. The data messages shall be contiguous. Subsequent reception
of an init command shall terminate the transmission. The transceiver unit shall turn on the
carrier at the start of the transmission.
-Activate the high audio tone {1150 HZ) and apply it to the receive-audio line.
Deactivate the high audio tone.
-Activate the low audio tone (770 HZ) and apply it to the receive-audio line.
-Deactivate the low audio tone.
-Initialize non-volatile memory. Set registration memory and called-address repertory
memory to zeros. Set lock state to active (locked).
35