Integral Gsm/Gprs/Umts Modem - Honeywell FE260 Operating Instructions Manual

FE260

3.5.2 Integral GSM/GPRS/UMTS modem

The FE260 can be optionally equipped with a GSM
used for data transmission via the GSM/GPRS or UMTS network (radio network, "mobile phone network").
With the FE260 with an integral GSM/GPRS modem the antenna required for this is included in the supplied
items.
Similarly, a mounting bracket for mounting the antenna (e.g. on the wall) is also included in the supplied
items.
Once the antenna has been mounted, the antenna cable has to be connected to the SMA
bottom side of the housing (→ Fig. 4, pos. "d", page 7).
To operate the modem you need a SIM
In case the data transmission should be originated by an analogue PSTN
must be enabled by the network provider. If in doubt, please contact your network provider.

Disconnect the FE260 from the power supply before you insert the SIM card into the
SIM holder.
Then close the SIM holder carefully, close the housing and switch on the power supply
again.

Disconnect the FE260 from the power supply before you mount or dismount the
antenna!

Take care that the FE260 is in secure area (non Ex) before you mount or dismount the
antenna!
1
Global System for Mobile Communications
2
General Packet Radio Service
3
Universal Mobile Telecommunications System
4 Sub-Miniature-A, coaxial antenna socket
5
Subscriber Identity Module
6
Public Switched Telephone Network
7
Circuit Switched Data
Operating Manual
1 2
/GPRS (2G) or a UMTS
5
card from your provider (e.g. D1 or D2 network).
3
modem (3G). The modems are
4
socket on the
6
data modem, the CSD
13
7
service