Multi Channel Surround Setup - Sony MHC-S90D Operating Instructions Manual

Multi channel surround
setup
For the best possible surround sound, all
speakers should be the same distance from the
listening position (A). However, this unit lets
you to place the center speaker up to 1.5 meters
closer (B) and the rear speakers up to
4.5 meters closer (C) to the listening position.
The front speakers can be placed from 1.0 to
12.0 meters from the listening position (A).
You can place the rear speakers either behind
you or to the side, depending on the shape of
your room (etc.).
When placing rear speakers to your side
A
C
When placing rear speakers behind you
A
C
Note
Do not place the center speaker farther away from the
listening position than the front speakers.
14
B
A
45°
C
90°
20°
B
A
45°
C
90°
20°
Specifying the speaker
parameters
1
Press SET UP.
2
Press P or p repeatedly to select "SP.
SET UP".
3
Press ENTER (A/V amplifier or remote).
4
Press P or p repeatedly to select the
parameter you want to adjust.
See the table on page 73 for the speaker
parameters.
5
Press O or o repeatedly to select the
setting you want.
The setting is stored.
6
Repeat steps 4 and 5 to set the speaker
parameters.
7
Press ENTER (A/V amplifier or remote).
x Center speaker selection (CENTER)
• If you connect a center speaker, select "YES".
• If you do not connect a center speaker, select
"NO". The sound of the center channel will be
output from the front speakers.
x Rear speaker selection (REAR)
• If you connect rear speakers, select "YES".
• If you do not connect rear speakers, select
"NO".
MHC-S90D 4-235-983-13(2) GB