Advertisement
ADJUSTING THE FOWLER BACK
The Fowler Back is infinitely adjustable from 0 degrees to 80 degrees.
Adjustments are made manually.
To raise the Fowler Back, simply lift up on the Fowler Back until it is raised
to the desired position.
To lower the Fowler Back, push down on the Fowler Back handle located on
either side of the table frame toward the head-end of the table. While holding the
handle down, use your free hand to support the Fowler Back as it is lowered.
!
CAUTION: The Fowler Back must be supported while it is being lowered.
ADVETISSEMENT: Le "Fowler Back" doit etre supporte au temps de
!
descendre.
PREVENTIVE MAINTENANCE
1.
Periodically check that the casters have not loosened in the legs.
Tighten if required.
2.
Check the restraining straps. The snaps should be in good condition
and the strap material should not be worn.
As required, clean all exterior painted surfaces, stretcher top and
Velcro
®
safety straps with a mild detergent solution.
SPECIFICATIONS
The MRI Fowler Back Stretcher is a lightweight, non-magnetic table built
from aluminum with non-magnetic casters.
Dimensions:
Tabletop: 72" l x 24" w (182.8 x 60.9 cm)
Overall: 74.5" l x 27.75" w x 34" h (189.3 x 70 x 86 cm)
Fowler Back: 0° to 80° infinitely adjustable, manual
Wheels: 5" locking casters
Finish: Powder coat
Patient Capacity: 500 lb (226.8 kg); weight tested to four times the patient
load rating.
Compliance: MR conditional; tested with Phillips 3T System
Weight: 110 lb (49.9 kg)
Shipping Weight: 225 lb (102 kg)
Authorized European Community Representative:
Prothia, Paris, France
0
Advertisement
