Table of Contents
Advertisement
[Frame]: The picture, including subjects that do
not move dynamically, is output in high
resolution.
[Audio Settings]
x [BD Audio MIX Setting]
[On]: Outputs the audio obtained by mixing the
interactive audio and secondary audio to the
primary audio.
[Off]: Outputs the primary audio only. Select
this when outputting HD audio signals to an AV
receiver.
x [Audio DRC]
You can compress the dynamic range of the
sound track.
[Auto]: Performs playback at the dynamic range
specified by the disc (BD-ROM only).
[Off]: No compression of dynamic range.
[On]: The system reproduces the sound track
with the kind of dynamic range that the
recording engineer intended.
x [Attenuate - AUDIO]
Distortion may occur when you listen to a
component connected to the AUDIO (AUDIO
IN L/R) jacks. You can prevent distortion by
reducing the input level on the unit.
[On]: Attenuates the input level. The output
level is changed.
[Off]: Normal input level.
x [Audio Output]
The system cannot output multi-channel sound
from both the HDMI OUT jack and system's
speakers simultaneously.
[Speaker]: Outputs multi-channel sound from
the system's speakers only.
[Speaker + HDMI]: Outputs multi-channel
sound from the system's speakers and 2-channel
linear PCM signals from the HDMI OUT jack.
54
GB
[HDMI]: Outputs sound from the HDMI OUT
jack only. Sound format depends on the
connected component.
Note
• When you set [Audio Output] to [HDMI], the
SOUND MODE, "D.BASS," "NIGHT MODE," and
"SUR.SETTING" functions are disabled.
• When the System Audio Control function (page 47)
is activated, this setting may change automatically.
x [Sound Effect]
You can set the system's sound effects (SOUND
MODE, "D.BASS," "NIGHT MODE," and
"SUR.SETTING"
to on/off.
)
[On]: Enables all of the system's sound effects.
The upper limit of sampling frequency is set to
48 kHz.
[Off]: The sound effects are disabled. Select this
when you do not want to set the upper limit of
sampling frequency.
x [Speaker Settings]
To obtain the best possible surround sound, set
the speakers. For details, see "Setting the
Speakers" (page 49).
x [Auto Calibration]
You can calibrate the appropriate settings
automatically. For details, see "Calibrating the
Appropriate Settings Automatically" (page 48).
Advertisement
Table of Contents
