Table of Contents
Advertisement
Identifying the unit with a
specific S-AIR sub unit
(Pairing operation)
For the surround amplifier
For the S-AIR receiver
When using S-AIR products, neighbors may
also receive your system’s sound if IDs are the
same, or you may receive sound from neighbors.
To prevent this, you can identify the unit with a
specific S-AIR sub unit by performing the
pairing operation.
When you perform pairing, wireless
transmission is activated between the paired
main unit and S-AIR sub unit only.
1
Place the S-AIR sub unit that you want
to pair near the unit.
2
Match the IDs of the unit and the S-AIR
sub unit.
• To set the ID of the unit, see “To set the ID
of the unit” (page 42).
• To set the ID of the surround amplifier,
refer to the operating instructions of the
surround amplifier.
• To set the ID of the S-AIR receiver, refer
to the operating instructions of the S-AIR
receiver.
3
Press HOME.
The home menu appears on the TV screen.
4
Press C/c to select
[Setup].
5
Press X/x to select [System Settings],
then press
.
6
Press X/x to select [S-AIR Settings],
then press
.
The [S-AIR Settings] display appears.
7
Press X/x to select [Pairing], then
press
.
8
Start pairing of the S-AIR sub unit.
x For the surround amplifier
Refer to the operating instructions of the
surround amplifier.
x For the S-AIR receiver
GB
Refer to the operating instructions of the
S-AIR receiver.
9
Press C/c to select [Start], then press
.
The unit starts pairing.
The PAIRING indicator of the surround
amplifier flashes when pairing starts.
When wireless transmission is activated,
the PAIRING indicator of the surround
amplifier turns on.
To cancel pairing, select [Cancel].
Note
• Perform pairing within several minutes of Step
9. If you do not, [Pairing failed. Retry?] appears
on the TV screen. To continue pairing, select
[OK] and press
, then start again from Step 8.
To cancel pairing, select [Cancel].
To cancel pairing
Change the ID of the main and sub unit
(page 42).
If wireless transmission is
unstable
For the surround amplifier
For the S-AIR receiver
If you use multiple wireless systems, such as
wireless LAN or Bluetooth, the transmission of
S-AIR signals or other wireless signals may be
unstable. In this case, the transmission may be
improved by changing the following [RF
Change] setting.
1
Press HOME.
The home menu appears on the TV screen.
2
Press C/c to select
[Setup].
3
Press X/x to select [System Settings],
then press
.
4
Press X/x to select [S-AIR Settings],
then press
.
The [S-AIR Settings] display appears.
5
Press X/x to select [RF Change], then
press
.
6
Press X/x to select the desired setting,
then press
.
Page 44
Advertisement
Table of Contents
