MAGIC FX MFX1201 User Manual page 16

User Manual MAGICFX® Stage Flame
7.
8.
9.
Page 15
Screw the aerosol can into the holder until it
is securely locked in place. Ensure that it is
securely in place.
Only replace an aerosol can during a
show when the Stage Flame is set to
"safety mode".
Consult the DMX settings to see how the
Stage Flame can be put into "safety mode".
The temperature will be rised after the
Stage Flame has been in use for a period
of time. So always let the Stage Flame
cool off before replacing the aerosol can.
Always remember that escaping gas can
ignite at high temperatures.
After you have inserted/replaced the
aerosol can, shut the cover of the Stage
Flame and secure the fasteners on the
side.
If you use a gas bottle, ensure that it is
located on a safe flat surface beyond the
reach of other heat sources.
Fit a propane gas reducer onto the gas
bottle.
Use a wrench to connect the reducer
and ensure that no gas can escape.
Ensure that the gas bottle cannot topple.
This would allow liquid gas to enter the
Stage Flame.