•
If the saddle had been refitted, remove it.
•
Install the battery (8) in its seat.
•
Position the positive cable (7) and secure it to the positive terminal (+), tight-
ening the screw (6).
The positive cable (7) must be positioned to the side of the battery (8).
•
Position the rubber protective cap on the positive terminal (+).
•
Position the negative cable (5) and secure it to the negative terminal (-),
tightening the screw (4).
The negative cable (5) must be positioned to the side of the battery (8).
04_09
•
Position the battery clamp (3).
•
Position the secondary fuse box (2).
•
Tighten the two screws (1).
•
Position and secure the rider saddle as described in the "saddle opening"
section.
04_10
Checking the electrolyte level
WARNING
THIS MOTORCYCLE IS EQUIPPED WITH A BATTERY THAT REQUIRES NO
MAINTENANCE OTHER THAN PERIODICALLY CHECKING STATE OF CHARGE.
Charging the battery
•
Remove the battery.
•
Get an adequate battery charger.
137