Resetting To Default Settings And Pass Levels; Backlight; Battery Low Message; Auto Power Down - Martindale Electric HPAT600/2 HANDYPAT Instruction Manual

2.20 Resetting to Default Settings and Pass Levels

(Factory Reset)
To reset all settings and pass levels to default (Refer to
2.7 for default settings and pass levels) enter the MENU
screen and use hi to select Reset to Def. and press
OK. All defaults will now be set and the HPAT600 will
return to the SELECT TEST screen.
Note: Resetting to defaults will NOT delete stored test
data.
2.21
The backlight is switched on and off by alternate
pressing of the button. It will not function if the
MENU screen is active or the h becomes enabled during
testing.

2.22 Battery Low Message

When the batteries discharge to a predetermined low
threshold value, the HPAT600 will display a 'Connect
charger' message.

2.23 Auto Power Down

If the HPAT600 remains inactive for a period of 10
minutes or the HPAT600 batteries approach a level
where the HPAT600 can no longer function correctly, the
HPAT600 will automatically power down. The message
'Auto power down' will be displayed on the screen for 3
seconds before auto power down.
When the HPAT600 is next powered up, by pressing
the green ON button, (after attaching battery charger
if necessary) the unit will return to the same state as
before Auto power down: Any test data that may have
14