Huawei OceanStor V3 Series Features Manual page 65

OceanStor V3 Series
Remote Replication Feature Guide for Block
4.
Step 5 Select synchronous remote replication primary and secondary resources.
1.
2.
3.
4.
5.
Step 6 Set properties of the remote replication pair.
1.
Issue 06 (2018-01-30)
NOTE
When you create a remote replication task using the storage resources created based on an application,
all available LUNs of the application are displayed in Primary Resource. For details about how to
create storage resources based on applications, see Creating Storage Resources Based on
Applications in the OceanStor V3 Series V300R006 Basic Storage Service Guide for Block. For
OceanStor 2000 V3 series (excluding 2600 V3 Video Surveillance Edition and 2800 V3), 5000 V3
series, and 6000 V3 series, you can configure the storage resources created based on applications. For
OceanStor 18000 V3 series, the storage resources created based on applications are not displayed when
you create a remote replication pair, because this type of storage resources is not supported by
OceanStor 18000 V3 series.
Click Next.
From the Remote device drop-down list, select the remote device where the secondary
resource resides.
NOTE
If no remote device exists, click Add to add one.
In the Primary Resource area, select the remote replication primary resource.
In the Secondary Resource area, select the remote replication secondary resource.
Click Add to Pairs.
The selected primary and secondary resources are added to Pairs.
Click Next.
On the Set Properties page, set the remote replication parameters based on your service
requirements.
Table 3-5 describes parameters of remote replication.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Configuring Remote Replication
57