Table of Contents
Advertisement
Installer section
D. PEBBLE ARRANGEMENTS
Place the Mat on top of the burner such that all the holes on the mat align
with the holes on the burner top plate.
Take eight of the pebbles and place them on top of the firebed area, such
that there are four pebbles at the back of the fire and four pebbles at the
front of the fire, as shown in the picture below.
The remainder of the pebble layout is now dependent upon gas type., so
follow the proceedure for the gas type below.
E. PEBBLE ARRANGEMENTS - NATURAL GAS
Place five of the remaining pebbles down the centre of the burner, lying
from front to back, as shwon in the picture below.
Place the last eleven pebbles on top of the thirteen existing pebbles as
shown in the picture below.
F. PEBBLE ARRANGEMENTS - LPG GAS
Place two of the Pebbles, one at each end of the burner, against the firebox
(1-2). Position another two pebbles at the very front of the burner, one either
side of the pilot shield (3-4). Place three more pebble at the rear of the
burner, ensuring that the Gas Ports at the rear of the burner are not blocked
(5 to 7). The picture below shows show the pattern should now look.
Now place a row of three pebbles such that it is sitting on top of the front
pebbles, already in place (8 to 10). Repeat this process with another row
of three pebbles, this time sitting on top of the rear two rows of pebbles
already in place (11 to 13). Take the final three pebbles and lay them on
top of the very rear row and up against the back plate of the firebox (14
to 16). The layout is now complete and should look like the picture below.
14
Advertisement
Table of Contents
