Advertisement
Airless Spray Setup
WARNING
To prevent injury when the applicator is not in use,
always relieve pressure if sprayer is being shut
down or left unattended.
Make sure sprayer is turned off and unplugged from power
source. Refer to your sprayer instruction manual for priming
and spray instructions.
Connect Applicator to Sprayer
1.
Attach supply hose to sprayer fluid outlet.
2.
Attach other end of supply hose to applicator swivel (17).
3.
Refer to sprayer instruction manual for priming
instructions.
Install Applicator Tip and Guard
WARNING
1.If equipment has recently been operated,
relieve pressure.
2.Using a pencil or similar object, insert seal
(20) into back of guard (18).
3.
Install guard (18) onto end of applicator (9).
4.
Insert tip (19) in guard (18). Tighten retaining nut.
Operation
Spraying
1.
Be sure the arrow shaped tip (19) faces forward (spray).
2.
Hold applicator perpendicular and approximately
40 in. (1 m) from surface. Move applicator first, then open
applicator to spray a test pattern.
3.
Slowly increase pump pressure until coverage is uniform
and even (see sprayer instruction manual for additional
information).
Aligning Spray
WARNING
1.Relieve pressure.
2.
Loosen guard
(3) Horizontal
retaining nut.
3.
Align guard (18)
horizontally to
spray a horizontal
pattern.
4.
Align guard (18)
vertically to spray
a vertical pattern.
2
Окрасочное оборудование GRACO
(4) Vertical
ti11908a
ti11909a
Clearing Clogs
WARNING
1.
Close applicator.
2.
Rotate tip (19) 180°. Open applicator into hopper or onto
ground to remove clog.
3.
Rotate tip (19) 180° back to spray position.
Cleanup
Flush applicator after each work shift and store in a dry
location. Do not leave the applicator or any parts in water or
cleaning solvents.
Air Spray Setup
WARNING
To prevent injury when the applicator is not in use,
always relieve pressure if sprayer is being shut
down or left unattended.
Connect Applicator to Sprayer
1.
Attach supply hose to sprayer fluid outlet.
2.
Attach other end of supply hose to applicator swivel (17).
3.
Install air hose to applicator check valve (8).
4.
Refer to sprayer instruction manual for priming
instructions.
Install Applicator Air Nozzle
WARNING
1.If equipment has recently been operated,
relieve pressure.
2.Install air nozzle (27) and retainer (10).
3.
Replace retainer with Fine Finish Kit (40) for finer finishes.
Operation
Spraying
1.
Set material flow (see sprayer instruction manual for addi-
tional information).
2.
Spray test pattern
3.
Turn air knob on and adjust, and/or select another air
nozzle, for desired pattern.
Note: Air continues to flow when handle is in off position to
keep material out of air passages.
Cleanup
Flush applicator after each work shift and store in a dry
location. Do not leave the applicator or any parts in water or
cleaning solvents.
312879D
Advertisement
