Configuration - Maple Systems HMC3-M0808P0401T Manual

HMC3-M1614Y

Configuration

Use MAPware-7000 to assign input (X and XW), output (Y and YW) and configuration (M and MW) memory
addresses to the module. These addresses are created according to the slot location of the module, where nn
refers to the slot number (ex. 01...05):
Function
X0-X15 Digital Inputs
Y0-Y13 Digital Outputs
High-speed Counter Option
HSC Input Pin
Quadrature Inputs
Counter Inputs
HSC Configuration Register
HSC Counter Register (Current Value)
HSC Preset Register
HSC Enable Bit
HSC Reset Bit
Output Flag
PWM Outputs
Output
PWM Configuration Register
Frequency Setting Register
ON Duty Setting Register (Duty Cycle)
Pulse Enable Flag
ON Duty Setting Error Flag
Frequency Setting Error Flag
Reference the table below when configuring each HSC Configuration Register:
Input Mode
Normal Input
High Speed,
Single Phase,
Up/Down Counter
Quadrature 4X
Reference the table below when configuring the PWM Configuration Registers:
Output Mode
Normal PWM (fixed frequency)
Normal PWM (variable frequency)
CW/CCW (fixed frequency)
CW/CCW (variable frequency)
Pulse/Direction (fixed frequency)
Pulse/Direction (variable frequency)
Trapezoidal (Fixed Pulse Mode)
HMC3000 Series I/O Module Guide
Xnn000-015 (XWnn00)
Ynn000-013 (YWnn00)
HSC Channel 1
X0
Pair 1
X0, X1
MWnn00
MWnn01
MWnn03
Mnn080
Mnn081
Y2
Channel 1
Y0
MWnn24
MWnn25
MWnn27
Mnn576
Mnn466
Mnn467
Output Mode
N/A
Output ON when preset is reached
Output ON when counter is enabled,
OFF when preset is reached
Output ON when preset is reached
Output ON when counter is enabled,
OFF when preset is reached
Register
HSC Channel 2
X2
Pair 2
X2, X3
MWnn06
MWnn07
MWnn09
Mnn176
Mnn177
Y3
Channel 2
Y1
MWnn30
MWnn31
MWnn33
Mnn577
Mnn471
Mnn472
Register Value
1
2
3
4
7
8
9
65
Access
Read Only
Read/Write
Read Only
Read Only
Read/Write
Read/Write
Read/Write
Read/Write
Read/Write
Read Only
Read/Write
Read/Write
Read/Write
Read/Write
Read Only
Read Only
Register Value
0
2
258
131
387
65