Periodic Reminder Messages; Diagnostic Messages - Master Spas LEGEND XTREME SERIES Owner's Manual

PERIODIC REMINDER MESSAGES
Message Frequency Action Required
CHECK PH
Every 7 days Test and adjust chemical levels per manufacturer's
instructions.
CLEAN FILTER Every 30 days
Remove, clean, and reinstall filter per manufacturer's
Instructions.
TESTGFCI
Every 30 days
Test &
reset GFCI per manufacturer's instructions.
DRAIN WATER
Every 90 days Drain and refill spa per manufacturer's instructions.
CHANGE Every 180 days If applicable, change mineral caitridge.
MINERAL
(fourth line blank before message repeats)
CARTRIDGE
CLEAN COVER
Every 180 days Clean and condition cover per manufacturer's instructions.
NEW FILTER
Every 364 days
Install new filter.
DIAGNOSTIC MESSAGES
Message
HTR TEMPLMT
SPATEMPLMT
FREEZECOND
SENSOR A
SERVICERQD
Frequency
No message on display.
Power has been cut off to the spa.
"Overheat" - The spa has shut down.
One of the Sensors has detected
1 l 8°F at the heater.
"Overheat" - The spa has shut down.
of the sensors has detected that
the spa water is 110°F.
"Ice" - Potential freeze condition
detected
Spa is shut down. The sensor that is
plugged into the Sensor "A" jack is
not working.
- 19 -
Action Required
The control panel will be disabled until power
returns. Spa settings will be preserved for 30
days with a battery back-up.
DO NOT ENTER THE WATER. Remove
the spa cover and allow water to cool. Once
The heater has cooled, reset by pushing any
button. If
spa does not reset, shut off the power
to the spa and call your dealer or service
organization.
DO NOT ENTER THE WATER. Remove One
the spa cover and allow water to cool. At
107°F the spa should automatically
reset. If
spa does not reset, shut off the power to the spa
and call your dealer or service organization.
No action required. Freeze protection (see
above) has initiated. The pumps will
automatically activate regardless of spa status.
If the problem persists,
contact your dealer or
service organization. (May appear temporarily
in an overheat situation and disappear when the
heater cools.)