Subscribe to Our Youtube Channel
Related Manuals for WITTUR HHL-W Line
Summary of Contents for WITTUR HHL-W Line
- Page 1 Home Lift - Elevating platform Date 07/10/2011 Sheet Test instructions Version 11117320015V02 Approved Subject to change without notice! EXCELLENCE IN COMPONENTS Original instructions...
-
Page 2: Table Of Contents
Home Lift - Elevating platform Date 07/10/2011 Sheet Test instructions Version 11117320015V02 Approved INDEX 1 Purpose and scope of application of these instructions. 2 Designations and terms. 3 Safety advice. 4 Description 4.1 Planning and measuring equipment 4.2 Failures Evaluation 4.3 Test methods 4.3.1 General tests... -
Page 3: Designations And Terms
Home Lift - Elevating platform Date 07/10/2011 Sheet Test instructions Version 11117320015V02 Approved 1 Purpose scope 3 Safety advice application these instructions. It is essential to comply with all applicable national safety regulations and legal provisions to prevent personal injury in assembly, service and repair work The purpose of these instructions is to on the product. - Page 4 - put signs on the platform well doors to warn Machine Directives 98/37/EC and 2006/42/EC. people that the lifting platform is shut down. Wittur cannot accept any warranty for safety components and parts not included in Wittur's 3.1.1.1. Malfunctions with an impact on...
-
Page 5: Description
Home Lift - Elevating platform Date 07/10/2011 Sheet Test instructions Version 11117320015V02 Approved The qualification shall be Negative (N) when 3.1.1.2. Defects the failure represents a serious risk for the user’s safety. The lifting platform is defective if: In the relative report (see Annexes 1 and 2) to the N qualified points, there must be the failures to repair or substitute, if needed. -
Page 6: Machinery Spaces
Home Lift - Elevating platform Date 07/10/2011 Sheet Test instructions Version 11117320015V02 Approved h) the alarm device, when activated, machinery cabinets, these must be done in a operates correctly; way that assures enough protection against i) the mechanical blocking device is dust, humidity and toxic gases. - Page 7 Home Lift - Elevating platform Date 07/10/2011 Sheet Test instructions Version 11117320015V02 Approved Check that the tank oil level is between the admissible values. Limitation of the ram stroke Verify that the piston stops on the top over travel (TOT) on the specifics of each project. Full load pressure Total load pressure measurement.
- Page 8 Home Lift - Elevating platform Date 07/10/2011 Sheet Test instructions Version 11117320015V02 Approved adjustment diagram. To reach an overspeed Check that the thermal protection of the unscrew the screw n 8 in the block of valves, installation against motor overload. then screw and unscrew the rupture valve to increase or decrease the rate of activation.
- Page 9 Home Lift - Elevating platform Date 07/10/2011 Sheet Test instructions Version 11117320015V02 Approved EN81-41 check that the phone line is in A switch must permit to cut the machine perfect condition and that the outgoing room/machinery cabinet lighting, and another communication from the car is established one the well lighting.
-
Page 10: Safety Gear Device
Top clearances Please check that, once the ram is in its WITTUR does not accept liabilities for damages ultimate position, the free vertical distance caused by inappropriate use or actions between the level of the highest area on the... - Page 11 Home Lift - Elevating platform Date 07/10/2011 Sheet Test instructions Version 11117320015V02 Approved B. Remove the safety clevis (2) from the device. Assembly and tests The test shall be made while the car is C. Out of the enclosure, pull the rope (3), in descending, with 1.1 times the rated load indicated direction...
-
Page 12: Responsibility
The Installation Company is the responsible of doing this final test, or contracting a Notified Body to do it according to this procedure, so as to notify WITTUR E.C., S.A. across the IE-S-01 model, Final Act of the platform or equivalent. Test report... -
Page 13: Test Report
Home Lift - Elevating platform Date 07/10/2011 Sheet Test instructions Version 11117320015V02 Approved Annex 1 Test report The examination certificate shall contain the following information. TEST REPORT Name of the examiner: ........................... examination certificate: ..........................examination N°: ............................. 1 Category, type and make or trade name: ....................2 Manufacturer's name and address: ...................... - Page 14 Home Lift - Elevating platform Date 07/10/2011 Sheet Test instructions Version 11117320015V02 Approved Annex 2 Check list form sample Take the following as sample for the check list. Subject to change without notice! EXCELLENCE IN COMPONENTS Original instructions...
Need help?
Do you have a question about the HHL-W Line and is the answer not in the manual?
Questions and answers