Final Transmission Oil - Yamaha Grand filano LTF125-I Owner's Manual

NOTICE
Do not use oils with a diesel
specification of "CD" or oils of a
higher quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
Be sure no foreign material en-
ters the crankcase.
7. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off
and check for the cause.
8. Turn the engine off, and then
check the oil level and correct it if
necessary.
Periodic maintenance and adjustment
ECA11671

Final transmission oil

The final transmission case must be
checked for oil leakage before each
ride. If any leakage is found, have a
Yamaha dealer check and repair your
motorcycle. In addition, the final trans-
mission oil must be changed as follows
at the intervals specified in the periodic
maintenance and lubrication chart.
1. Start the engine and warm up the
final transmission oil by riding the
motorcycle for several minutes.
2. Stop the engine and then place
the motorcycle on the center-
stand.
3. Place an oil pan under the final
transmission case to collect the
used oil.
4. Remove the final transmission oil
filler cap and its O-ring from the fi-
nal transmission case.
9-12
EAU67821
1. Final transmission oil filler cap
2. O-ring
5. Remove the final transmission oil
drain bolt and its gasket to drain
the oil from the final transmission
case.
1
1. Final transmission oil drain bolt
1
2
9