Remote Mgmt - ZyXEL Communications LTE3316-M604 User Manual

Table 58 Configuration > Management > MGMT Interface > Local MGMT (continued)
LABEL
Enable
Port
Cancel
Apply

21.5 Remote MGMT

Use this screen to configure through which IP address the Zyxel Device can be accessed. You can also
specify the port numbers the IP addresses must use to connect to the Zyxel Device. Click Configuration >
Management > MGMT Interface > Remote MGMT to open the following screen.
Note: The firewall will be disabled when remote management is enabled. To activate the
firewall, you'll need to create a new firewall rule to allow the remote management
traffic to come in from the WAN side.
Figure 79 Configuration > Management > MGMT Interface > Remote MGMT
The following table describes the labels in this screen.
Table 59 Configuration > Management > MGMT Interface > Remote MGMT
LABEL
HTTPS
Enable
IP address
Netmask
Chapter 21 MGMT Interface
DESCRIPTION
Select this to allow a device to access the Zyxel Device CLI using this service.
You may change the server port number for the Telnet service if needed. However
you must use the same port number in order to use that service for remote
management.
Click Cancel to return the screen to its last-saved settings.
Click Apply to save your changes back to the Zyxel Device.
DESCRIPTION
Select this check box to allow access to the LTE Device from the IP address and
activate the HTTPS settings you've made in the Local MGMT screen.
This is the IP address of a computer that may use to access the Zyxel Device.
This is the subnet mask identifying a computer that may access remotely to the Zyxel
Device.
LTE3316 Series User's Guide
139