Pioneer PDP-503CMX Product Training Manual page 80

Integrator Mode
Setting OFF TIMER
This function automatically puts the power supply on standby status after a set time has elapsed. To alleviate screen
burn-in, the full mask can be displayed for a set time before standby status goes into effect.
If settings are made as follows,
TIMER: ON
DISPLAY TIME: 10H
MASK TIME: 2.5H
MASK COLOR: WHITE
then after 10 hours of normal operation, a mask will be displayed (white) for 2.5 hours. Then, standby status will go
into effect. (At this time, the power supply will remain on for last memory.)
Factory preset : TIMER: OFF
DISPLAY TIME: 1H
MASK TIME: 0.0H
MASK COLOR: WHITE
1 Enter integrator mode.
(See 5.4.1, "About the integrator mode.")
The set ID will be displayed on the upper right where the
"– –" mark is.
Select OFF TIMER under OPTION.
2 Select the item and use the 2 and 3 buttons to change the
setting.
The TIMER setting will switch between OFF and ON.
DISPLAY TIME will change in one-hour increments, between
1 and 24H, as follows: ··· Ô 1H Ô 2H Ô ··· Ô 24H Ô 1H···
MASK TIME will change in half-hour increments, between
0.0 and 9.5H, as follows: ··· Ô 0.0H Ô 0.5H Ô ··· Ô 9.5H
Ô 0.0H Ô ···
MASK COLOR will change as follows: ··· Ô WHITE Ô RED
Ô GREEN Ô BLUE Ô ···
Press the SET button to retun to screen 1.
OFF TIMER is shared by all inputs (INPUT1~5).
80
Screen 1
I NTEGRATOR MENU
PICTURE WHITE BAL
O S D
B A U D R A T E
O F F T I M E R
]
F U L L M A K S
S I D E M A K S
M A K S C O T N
O R B I T E R M
I N V E R S E M
C O L O R M O E D
SELECT SET
Screen 2
]
O F F
T I ME R
D S I P L A Y
M S A K T I M
M S A K C O O L
SELECT
I NPUT 1
– –
SCREEN SET UP OPTION
: O N
: 4 8 0 0 B P S
: O F / F 1 / 0 . 0 / W
: O F F
: 1 2 8 / 1 2 8 / 1 2 8
R O L : ON
O E D : O F F
O E D : O F F
: M O E D 1
ENTER MENU EXIT
T I ME R
: O F F
T I ME : 1 H
E : 0 . 0 H
R : W H I T E
MENU EXIT
CHANGE
SET SET