Pioneer PDP-503CMX Product Training Manual page 5

2. In Menu Mode
AUTO FUNCTION
• A function to switch to this input automatically, when a signal is
inputted to the input which was selected by this setting.
Automatically it goes back to previous input when there is no
input signal in the input.
• This function works only with "INPUT1" and "INPUT4".
• For the "INPUT1", this function works only with Composite
SYNC and Separate SYNC.
POWER CONTROL
• To switch the settings "Normal Display", "Linear Brightness", and
"Power Save".
1. Normal Display : Almost the same as PDP-502 setting
"ABL ON"
2. Linear Brightness : Almost the same as PDP-502 setting
"ABL OFF"
3. Power Save : New function from PDP-503
A function to lower the peak brightness
and lowers power consumption.
• Able to set up using RS-232C command (1: PWN / 2:PWS /
3:PWL)
INPUT LABEL
• A function to change "INPUT LABEL" of each input.
• It is able to set up max. of eight letters.
PURECINEMA
• A function to convert 480i to 480P based on 2-3 pull-down data.
• There are three settings; OFF, STANDARD, and HQ.
• Able to set up input signal NTSC/480i only
• Able to set up using RS-232C command (PUN/PUS/PUH)
DIGITAL NR
• Setting up digital noise reduction.
• There are four settings; OFF, LOW, MIDDLE, and HIGH.
• It is effective only in the case of a VIDEO (NTSC) signal input.
• Able to set up using RS-232C command (NRN/NRL/NRM/NRH)
COLOR TEMP
• A function that changes setting of the colors TEMP.
• There are six settings: LOW (approx. –3000K), MID LOW
(approx. –2000K), MIDDLE(+/- 0K), MID HIGH(approx.
+1000K), HIGH(approx. +2000K)
• It is effective only in the case of a VIDEO (NTSC) signal input.
• Able to set up using RS-232C command
(CT1/CT2/CT3/CT4/CT5)
5