Pioneer PDP-503CMX Product Training Manual page 72

Integrator Mode
Setting the 4-screen display (2x2 mode)
This function is for large screen display involving four units. (No consideration has been given to joints.)
For 4-screen display, set 2x2 to ON and then set LAYOUT in keeping with the positioning illustrated below.
Regular display
Factory preset : 2x2: OFF
LAYOUT: UP LEFT
1 Enter integrator mode. (See 5.4.1, "Integrator mode.")
The set ID will be displayed on the upper right where the
"– –" mark is.
Select 2x2 MODE for SET UP.
2 Move the cursor to 2x2 and use the 2 and 3 buttons to
change the setting.
Each time the 2 and 3 buttons are pressed, the setting
will switch between OFF and ON.
Move the cursor to LAYOUT and use the 2 and 3 buttons
to change the setting.
Each time the 2 and 3 buttons are pressed, the setting
will change as follows: UP LEFT Ô DOWN LEFT Ô UP
RIGHT Ô DOWN RIGHT Ô ···
Press the SET button to return to screen 1.
Make 2x2 MODE settings for each input (INPUT 1~5).
(NOTE) Four-screen display cannot be used with reversed display in MIRROR MODE. (Settings, however, can be
changed.)
72
4-screen display
UP LEFT
DOWN LEFT
Screen 1
]
Screen 2
]
UP RIGHT
DOWN RIGHT
I NTEGRATOR MENU – –
PICTURE WHITE BAL SCREEN SET UP
2 X 2 M O E D : O F F / U L
B R T EN H A N C E : O F F
S U B V O L U ME : 6 0
SELECT SET ENTER MENU
2 X 2 MOD E
2 X 2 : O N
L Y U A O T : U P L E F T
MENU
SELECT CHANGE
SET
I NPUT 1
OPTION
EXIT
EXIT
SET