Pioneer PDP-503CMX Product Training Manual page 75

Setting component input #
INPUT 1 and 2 handle two kinds of component picture signals.
Set them in accordance with the peripheral devices used.
Make each of the settings for INPUT 1 and 2, in accordance with the following.
For Y Pb Pr input (from high-vision devices, etc.) = select VIDEO INPUT: COMPONENT1
For Y Cb Cr input (from DVD players, etc.)
Set-able condition
Factory preset
1 Enter integrator mode.
(See 5.4.1, "About the integrator mode.")
The set ID will be displayed on the upper right where the
"– –" mark is.
Select SET UP.
2 Move the cursor to VIDEO INPUT and use the SET button
to change the setting.
Each time the SET button is pressed, the setting will change
between COMPONENT1 and COMPONENT2.
: INPUT 1 and 2, during video signal input (other than personal computer signals)
: COMPONENT2 for 525i, 525p, 625i and 625p input
COMPONENT1 for 1125i, 1125p and 750p input
= select VIDEO INPUT: COMPONENT2
Screen 1
I NTEGRATOR MENU
]
Screen 2
I NTEGRATOR MENU
]
Integrator Mode
I NPUT 1
– –
PICTURE WHITE BAL SCREEN SET UP
2 X 2 M O E D : O F F / U L
B R T EN H A N C E : O F F
H D T V M O D E : 1 0 3 5 i
V I D E O I N P U T : COMPONE N T 1
S U B V O L U ME : 6 0
SELECT SET ENTER MENU
– –
PICTURE WHITE BAL SCREEN SET UP
2 X 2 M O E D : O F F / U L
B R T EN H A N C E : O F F
H D T V M O D E : 1 0 3 5 i
V I D E O I N P U T : COMPONE N T 1
S U B V O L U ME : 6 0
SELECT SET CHANGE MENU
OPTION
EXIT
I NPUT 1
OPTION
EXIT
75