Toshiba H9 Quick Start Manual page 40

Past Trip 1 — This function records and displays the last trip incurred. Subsequent trips will replace
Past Trip 1. As trip records are replaced they are shifted to the next level of the Past Trip locations
until being deleted (i.e., Past Trip 1 is moved to Past Trip 2 and then to 3 until being shifted out of 4).
Once shifted out of Past Trip 4 the record is deleted. If no trips have occurred since the last reset,
None is displayed for each trip record.
Past Trip 2 — Past Trip information or None.
Past Trip 3 — Past Trip information or None.
Past Trip 4 — Past Trip information or None.
Note: An improper H9 ASD setup may cause some trips — reset the H9 ASD to the
Factory Default settings before pursuing a systemic malfunction (Program 
Utilities  Type Reset  Reset to Factory Settings).
Direction — Displays the Direction command (forward/reverse).
Discrete Input Terminals — Displays the status (Activated = reverse video) of the discrete input
terminals of the Terminal Board.
Discrete Output Terminals — Displays the status (Activated = reverse video) of the discrete
output lines of the Terminal Board.
Main Monitor Selections
Two (2) Monitor Mode
on the Frequency Command screen while the H9 ASD is running.
The selected items, along with their real-time values, are displayed on the Frequency Command screen
while running. Not all Monitor Mode items are available for display on the Frequency Command
screen. The available items are underlined on
Any two of the underlined items may be selected from the listing at Program Utilities  Main
Monitor Selections. Select an item from the Monitor 1 listing and another item from the Monitor 2
listing to be displayed as shown in
H9 ASD Quick Start Guide
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
items may be selected from the Main Monitor Selections screen to be displayed
pg. 31
Figure 22 on pg. 28
and pg. 32.
(DC Voltage and Output Current shown).
33