Status Number; Command Overview - EUCHNER EKS Manual

Manual EKS Electronic-Key Adapter Ethernet TCP/IP
8.4

Command overview

Description
Program Electronic-Key
Read Electronic-Key
(also read the serial number)
Read the Electronic-Key status
8.5 Status numbers
Value Description
00 No error
hex
02 Electronic-Key not in the operating distance
hex
03 Parity bit error on read-only Electronic-Key
hex
06 Write process interrupted. Start address or number of bytes is not a multiple of the block size 4
hex
Read attempt when the Electronic-Key adapter is set to read/write Electronic-Key and a read-only
17
hex
Electronic-Key is inserted
Read attempt when the Electronic-Key adapter is set to read-only Electronic-Key and a read/write
18
hex
Electronic-Key is inserted
4x General Electronic-Key communication error (renewed write or read process necessary)
hex
50 Write attempt despite enabled write protection
hex
61 Maximum permissible number of TCP/IP connections exceeded
hex
2100420-03-05/19
Command message
TP (see chapter 8.3.1)
TL (see chapters 8.3.2 and 8.3.3)
Ek (see chapter 8.3.4)
Subject to technical modifications
Reply message
RF (see chapter 8.3.1)
RL (see chapter 8.3.2)
or
RF (see chapter 8.3.2)
Ek (see chapter 8.3.4)
Page 31/34