Advertisement
Configuring the VR1000 Using the WebUI
Files tab
Use the file tab to upload files and download log files from the
receiver.
System
The System tab can be used to upgrade both GNSS firmware or
carrier board firmware. You can add subscription codes on this
screen.
Use the buttons at the bottom of the screen:
Note: The filesystem cannot be used when Bluetooth is enabled. If
Bluetooth is enabled, an option will be given to disable Bluetooth.
875-0422-10 Vector VR1000 QRG Rev A1
March 29, 2019
• Format Disk-format the internal storage
• Self Test- run a receiver self-test
• Factory Restore- restore the unit to factory settings
• Reboot-reboot the unit
, Continued
Continued on next page
Page 17 of 36
Advertisement
