5. Selecting Measurement Units
Select required units of measurement. Pressing and releasing the 'UNITS' button will step onto the next
available unit of measurement.
TIP:
Required units of measurement are not selectable.
a)
Conversion cannot be displayed within available digits on display, thus conversion is not
allowed.
b)
Units required have been disabled. See SET UP.
6. Selecting Measurement Mode
Press required button, see below:
Button
DIAL & ELECTRONIC
CLICK & CAM
TIP:
Readings in CLICK & CAM mode are inconsistent.
Change FIRST PEAK SENSITIVITY to be less sensitive, see THRESHOLDS menu in SET UP.
7. Fitting Hex Drive Adapter
Fit adapter supplied to hex drive of transducer. Fit the tool to be calibrated / tested to the square drive of the
adapter.
8. Operate Tool to Be Calibrated / Tested
Apply force to tool smoothly (do not snatch). Follow instructions for torque tool being tested.
Use
Hold highest signal.
Reset by pressing
Bending beam
wrenches &
Dial type
wrenches.
Captures the FIRST
Preset
PEAK of torque and
(click type)
displays this for the
wrenches.
selected AUTO RESET
HOLD TIME before
automatically resetting.
How it works
ZERO
Visual representation
AUTO RESET HOLD TIME
7