D-Link DVG-G5402SP User Manual page 6

DVG-G5402SP User's Manual
Rear Panel
1. Line: Connect to your original telephone line on the wall jack with RJ-11 cable.
2. Phone Port (1-2): Connect to your phones using standard phone cabling (RJ-11).
3. LAN: Connect to your Ethernet enabled computers using Ethernet cabling.
4. WAN: Connect to your broadband modem using an Ethernet cable.
5. Power Receptor: Receptor for the provided power adapter.
6. Ground: A conducting connection with the earth Connect with the ground so as to make the earth a
part of an electrical circuit using metal wire.
7. Antenna: Connect to a wireless network.
WARNING: DO NOT
phone port directly to a PSTN line (FXS to PSTN) or to an internal PBX line (FXS to PBX extension).
Doing so may damage your VoIP gateway.
Use Reset Button to restore factory default settings (IP address, Login ID and Password):
1. Disconnect the power plug.
2. Press and hold the reset button for 6 seconds.
3. Reconnect the power plug while pressing down on the reset button.
4. Release the reset button after 6 seconds. Factory settings will be restored.
D-Link Systems, Inc.
(1) connect the phone ports to each other (FXS to FXS) or (2) connect any
Telephone Interface Description
6