D-Link DVG-G5402SP User Manual page 51

DVG-G5402SP User's Manual
CO Line Type: Select PSTN (48V) or PABX (24V) for the CO line type connected to PSTN port.
FXS Chip Option 1: Check the box to avoid mis-detecting the loop state of a subscriber line or PBX user
loop from FXS interface. In some cases, the off-hook voltage might cause the FXS interface mis-detect the
idle and the active state, in order to avoid this situation, un-check this feature.
ADVANCED → VoIP → LINE SETTINGS
Ring (Early Media) Time Limit[10 - 600secs]: Enter the timeout to cancel a call if no one answers the
phone.
Enable End of Digit Tone: Check the box to activate the function of playing a "Beep-Beep" tone to notify
the user that the call is in progress.
Force Calling Thru PSTN code: Enter the code to get a PSTN line before dialing out. For example: If you
specify code "33" in this option and would like dial "23456789" via a PSTN line: Dial "33" and you will hear
dial tone from the PSTN line, now you're able to dial "23456789" via PSTN line.
Early Media Treatment: Check the box to send the one-way RTP immediately when a connection with a
VoIP service provider has been set up.
Loop Current Drop Trigger Time: Enter the time to avoid the line being engaged when FXS port is
connected to PBX. It stops the loop current from FXS port when FXS port is playing busy tone. The setting
"0" zero is to disable this function.
Loop Current Drop Duration: Enter the drop duration for loop current.
Enable ROH: Check the box to play Receiver Off-Hook tone in order to notify user to hang up the phone
set if FXS is off-hook for more than 20 seconds.
D-Link Systems, Inc.
ADVANCED
51